Page Comparison

Record/Pause - Used for capture control.

When the Record button is pressed on the front of the appliance to start an ad hoc capture, the appliance uses the product group that is set in the ESS and designated as the "One-Touch Product Group". For more information, please see One-Touch Product Group configuration and "What is the One-Touch Profile" in our FAQs section.

LED Behavior: This button is backlit by a LED that behaves differently based on the current Recording State

• • Idle: Solid White
  • Recording: Solid Red
  • Paused: Flashing between Red and Off
  • Prerolling and initializing: Flashing between Red and White
  • Stopping: Solid White

Stop - Used for capture control.

LED Behavior: This button is backlit by a LED that behaves differently based on the current Recording State

• • Idle: Solid White
  • Recording: Solid Blue
  • Paused: Solid Blue
  • Prerolling and Initializing: Solid Blue
  • Stopping: Flashing between Blue and Off

The current local time of the device, in HH:MM:SS AM/PM  (i.e. 10:00:40 AM)

• Idle:  Default state of the device when no capture task or publishing task is occurring.  When the device is in this state, any action can be performed.
• Recording (with Timer):
  
  • For Ad Hoc Captures:
    
    • Displays the "Time Remaining" based on the default ad hoc capture length of 2 hours.
  • For Scheduled Captures:
    
    • Displays the "Time Remaining", which counts the timer down from the length of the scheduled capture.
    • Displays an option to Extend Recording by 5-minute increments (up to 1 hour). This will require confirmation by the user.
• Paused: Displayed while the capture is paused.
• Stopping (with Timer): Displays the "Time Remaining", which counts down while the device is finalizing the capture.
• Pre-Rolling: 
  • For Ad Hoc Captures:
    
    • Displays for a brief period while the device is in communication with the ESS prior to the start of the capture.
  • For Scheduled Captures:
    
    • Displays for 5 minutes prior to the start of the capture which allows the user to start the capture early. This will require confirmation by the user.
• Initializing: This state will appear while a Device Configuration file is being applied to the device. This status also appears briefly after initiating an ad hoc capture but before the pre-rolling status.

• Recording Icon: Shows an icon representing the current Recording State. 
  • Paused/Pre-Rolling:  
  • Recording:  
  • Idle/Stopping:
• ESS Connectivity Icon: Shows whether or not the device is currently connected to an ESS. 
  • Connected:  
  • Disconnected:
• The status bar will display an icon when the headphone jack is in use
• The status bar will display an icon when in recovery mode, for more information please see our FAQs section.
• The status bar will display an animated icon while the device is uploading a capture.
• Device message codes: E1 through E12, for more information please see the Device Messages section below.