...

Manual Method

1. Perform a manual uninstallation of the Personal Capture software via the Add/Remove Programs option within the Control Panel.
2. Log into the Active Learning Platform.
3. Click the Settings menu to open it and select Downloads, as shown in the below figure.
4. Click the Windows Download link from the Personal Capture section of the Downloads page, shown below. The installer must be run locally, so save the file to your computer.
   
5. While logged into the system as an administrator, run the downloaded .EXE file to install

...

1. Locate the downloaded Echo360PersonalCaptureInstaller.exe file. It should be located in the Downloads folder.
2. On In the warning message that appears, click Open.
3. Once the installer is launched, follow the prompts to complete the installation.

...

1. Perform a command line uninstallation of any client installs. Content and logs will remain in the specified location.
2. Download the ALP Echo360 Personal Capture Windows installer. In ALPEcho360, it's available from the Settings > Download menu.
3. Proceed with a command line installation of any clients, detailed instructions can be found here.

...

1. Perform a manual uninstallation of the Classroom Capture software via the Add/Remove Programs Control Panel
2. Log into the Active Learning Platform as an Administrator.
3. Click the Settings menu to open it and select Downloads, as shown in the below figure.
4. Click the Windows Download link from the Software Capture section of the Downloads page, shown below. The installer must be run locally, so save the file to your computer. 
   
5. While logged into the system as an administrator, run the downloaded .EXE file to install

...

1. Perform a command line uninstallation of any client installs. Content and logs will remain in the specified location. 
2. Download the ALP Echo360 Classroom Capture Windows installer. In ALPEcho360, it's available from the Settings > Download menu.
3. Proceed with a command line installation of any clients, detailed instructions can be found here.

SafeCapture HD

The SCHD is a fully automated capture hardware that records class content and uploads the recordings for processing and publishing.

1. Perform a device reset.
2. Insert a USB thumb drive into the computer you are using; this will be where you save the device configuration file (device.xml). Please note that the USB drive should be blank and FAT-32 formatted.
3. In On the Active Learning Platform, click the Settings icon in the upper-right of the screen (it looks like a gear).
4. Select Configurations from the list.
5. Select the Default Room Configurations tab.
6. Make any necessary changes to the device/room configurations settings. These can be changed later for individual devices if necessary.
7. Scroll to the bottom of the page and click Download. Alternately, click Save and Download to retain any changes you made. Otherwise, the settings will revert to those that appeared when you opened the tab.
8. Save or move the downloaded device.xml file to the ROOT location on the thumb drive (NOT in a sub-folder). Whether you save or move depends on your browser download settings. DO NOT change the name of the file.
9. Go to the SCHD device. If necessary, turn it on and make sure it has fully initialized (wait about five minutes).
10. Insert the thumb drive containing the device.xml file into the USB port of the SCHD. Allow the device to upload and process the configuration file before removing the thumb drive.
11. Repeat the last two steps for each device that can use the downloaded configuration settings.

...