Versions Compared

Version Old Version 1 New Version Current
Changes made by

Hannah Petty

Hannah Petty

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Panel

In this section:

Table of Contents
maxLevel2
minLevel2

Overview

See See Manage Classroom Capture Sources to  to configure devices for use with a podium PC running Classroom Capture software.

...

Child pages (Children Display)

Device status

Information regarding your devices will be displayed on the Configuration -> Devices tab of your ESS.

SummaryOrganizationTypeCapture StatusLog Upload StatusUp Time

This section will display information regarding your device.

  • MAC address
  • Campus
  • Building
  • Device type and license
The Organization to which the device is assigned.

The type of device.

  • Capture Appliance
  • SafeCapture HD
  • Echo360 PRO
  • Classroom Capture
  • Media Processor

The current status of your device.

  • Overdue
  • Error
  • Idle
  • Active
  • n/a

The current upload status of the device logs.

  • Overdue
  • Error
  • Idle
  • Active
The amount of time the device has been online and registered with the ESS.
Panel
titleWhat does the status mean?
borderStylesolid

Overdue:

For both the Capture Status and the Log Upload Status.  This means that the device is not in communication with the ESS.

Expand
titleWhat do I do if my device is Overdue?

Here are some basic troubleshooting steps in escalating order for an Overdue device:

1. Make sure the device is plugged in and powered on.

2. Make sure the device has an ethernet connection and, if the device is an SCHD, that the ESS Comm light is green. If the device is a PRO, make sure that the Front Panel displays a connected icon:

About the LEDs on the EchoSystem SafeCapture HD

Echo360 PRO Status Screen

3. Once those basics have been confirmed, FAT32 format a blank USB drive and place it into the USB port on the device.

4. Wait a couple of minutes and then remove the USB drive from the device.

5. Check the USB drive for any writeback files.

-If there are no writeback files, proceed to step 8

6. Make sure that the IP address assigned to the device (from the writeback files) is valid.

7. From the Configuration -> Devices -> Device details page download the Device Configuration File and feed it back to the device in question.

8. Do a device reset:

Reset an Appliance to Factory Defaults

If the device reset is unsuccessful, please contact Technical Support.

Error:

Capture Status: this means that the last capture on the device ended in an error. Please note that this status is displayed only for a short time immediately after the capture ends in an Error state.

Log Upload Status: this means that something is preventing the device from uploading logs to the server.  Please contact Technical Support.

Idle:

Capture Status: this means that the device is not currently Active or in use.

Log Upload Status: this means that the device is not currently uploading logs.

Active:

Capture Status: this means that the is currently capturing.

Log Upload Status: this means that the device is currently uploading its logs.

N/A:

This means that the device in question is not capable of capturing because it is a Media Processor.